/*
 * Register bits for Wolfson WM97xx series of codecs
 */
 
#ifndef _WM97XX_H_
#define _WM97XX_H_

#include <linux/ac97_codec.h>	/* AC97 control layer */

/*
 * WM97xx AC97 Touchscreen registers
 */
#define AC97_WM97XX_DIGITISER1		0x76
#define AC97_WM97XX_DIGITISER2		0x78
#define AC97_WM97XX_DIGITISER_RD	0x7a

/*
 * WM97xx register bits
 */
#define WM97XX_POLL			0x8000		/* initiate a polling measurement */
#define WM97XX_ADCSEL_X		0x1000		/* x coord measurement */
#define WM97XX_ADCSEL_Y		0x2000		/* y coord measurement */
#define WM97XX_ADCSEL_PRES	0x3000		/* pressure measurement */
#define WM97XX_COO			0x0800		/* enable coordinate mode */
#define WM97XX_CTC			0x0400		/* enable continuous mode */
#define WM97XX_CM_RATE_93	0x0000		/* 93.75Hz continuous rate */
#define WM97XX_CM_RATE_187	0x0100		/* 187.5Hz continuous rate */
#define WM97XX_CM_RATE_375	0x0200		/* 375Hz continuous rate */
#define WM97XX_CM_RATE_750	0x0300		/* 750Hz continuous rate */
#define WM97XX_CM_RATE_8K	0x00f0		/* 8kHz continuous rate */
#define WM97XX_CM_RATE_12K	0x01f0		/* 12kHz continuous rate */
#define WM97XX_CM_RATE_24K	0x02f0		/* 24kHz continuous rate */
#define WM97XX_CM_RATE_48K	0x03f0		/* 48kHz continuous rate */
#define WM97XX_DELAY(i)		((i << 4) & 0x00f0)	/* sample delay times */
#define WM97XX_SLEN			0x0008		/* slot read back enable */
#define WM97XX_SLT(i)		((i - 5) & 0x7)	/* touchpanel slot selection (5-11) */
#define WM97XX_PRP_DETW		0x4000		/* pen detect on, digitiser off, wake up */
#define WM97XX_PRP_DET		0x8000		/* pen detect on, digitiser off, no wake up */
#define WM97XX_PRP_DET_DIG	0xc000		/* pen detect on, digitiser on */
#define WM97XX_RPR			0x2000		/* wake up on pen down */
#define WM97XX_PEN_DOWN     0x8000     /* pen is down */

/* WM9712 Bits */
#define WM9712_45W			0x1000		/* set for 5-wire touchscreen */
#define WM9712_PDEN			0x0800		/* measure only when pen down */
#define WM9712_WAIT			0x0200		/* wait until adc is read before next sample */
#define WM9712_PIL			0x0100		/* current used for pressure measurement. set 400uA else 200uA */ 
#define WM9712_MASK_HI		0x0040		/* hi on mask pin (47) stops conversions */
#define WM9712_MASK_EDGE	0x0080		/* rising/falling edge on pin delays sample */
#define	WM9712_MASK_SYNC	0x00c0		/* rising/falling edge on mask initiates sample */
#define WM9712_RPU(i)		(i&0x3f)	/* internal pull up on pen detect (64k / rpu) */
#define WM9712_ADCSEL_COMP1	0x4000		/* COMP1/AUX1 measurement (pin29) */
#define WM9712_ADCSEL_COMP2	0x5000		/* COMP2/AUX2 measurement (pin30) */
#define WM9712_ADCSEL_BMON	0x6000		/* BMON/AUX3 measurement (pin31) */
#define WM9712_ADCSEL_WIPER	0x7000		/* WIPER/AUX4 measurement (pin12) */
#define WM9712_PD(i)		(0x1 << i)  /* power management */ 

/* WM9712 Registers */
#define AC97_WM9712_POWER			0x24
#define AC97_WM9712_REV				0x58

/* WM9705 Bits */
#define WM9705_PDEN			0x1000		/* measure only when pen is down */
#define WM9705_PINV			0x0800		/* inverts sense of pen down output */
#define WM9705_BSEN			0x0400		/* BUSY flag enable, pin47 is 1 when busy */
#define WM9705_BINV			0x0200		/* invert BUSY (pin47) output */
#define WM9705_WAIT			0x0100		/* wait until adc is read before next sample */
#define WM9705_PIL			0x0080		/* current used for pressure measurement. set 400uA else 200uA */ 
#define WM9705_PHIZ			0x0040		/* set PHONE and PCBEEP inputs to high impedance */
#define WM9705_MASK_HI		0x0010		/* hi on mask stops conversions */
#define WM9705_MASK_EDGE	0x0020		/* rising/falling edge on pin delays sample */
#define	WM9705_MASK_SYNC	0x0030		/* rising/falling edge on mask initiates sample */
#define WM9705_PDD(i)		(i & 0x000f) /* pen detect comparator threshold */
#define WM9705_ADCSEL_BMON	0x4000		/* BMON measurement */
#define WM9705_ADCSEL_AUX	0x5000		/* AUX measurement */
#define WM9705_ADCSEL_PHONE	0x6000		/* PHONE measurement */
#define WM9705_ADCSEL_PCBEEP 0x7000		/* PCBEEP measurement */

/* AUX ADC ID's */
#define TS_COMP1			0x0
#define TS_COMP2			0x1
#define TS_BMON				0x2
#define TS_WIPER			0x3

/* ID numbers */
#define WM97XX_ID1			0x574d
#define WM9712_ID2			0x4c12
#define WM9705_ID2			0x4c05

#define AC97_LINK_FRAME		21			/* time in uS for AC97 link frame */

void register_touchscreen_codec(struct ac97_codec *codec);
void unregister_touchscreen_codec(struct ac97_codec *codec);

#endif