U92L BMC firmware and SDR (FBW0201) Release memo for 120Ra-1

1. Revision

	BMC FW Rev 01.17
	SDR Rev.01.00

2. Release data
  
   - 16000M21.EXE    Firmware and SDR update data

3. The change contents

  It is initial release for 120Ra-1. 

4. FW/SDR Upgrade Instructions
4.1 Creating a Bootable Floppy
    You must use a DOS system to create the bootable floppy.
    1)Place an unformatted floppy diskette in the floppy drive and format
      the floppy using the /S option. example: "format a: /s"
    2)Alternatively, place a formatted floppy in the floppy drive and use
      the "sys" command. example: "sys a:"
    3)Place a file in the root directory.
      example: "A:\> copy DOS\ANSI.sys a:\"

4.2 Making a FW/SDR Upgrade Floppy
    1)Follow the instructions (above) for creating a bootable floppy to
      create a bootable floppy diskette.
    2)Insert the bootable floppy into drive a:.
    3)Execute the 16000M21.EXE file onto the bootable floppy.

4.3 Upgrading a FW/SDR
    1)Place the bootable floppy containing the FW/SDR into drive a: of the
      system that you want to upgrade and boot the system while the floppy
      diskette is in the drive.
    3)Boot the system from the floppy disk drive. Automatically, FW/SDR is
      updated. 
    4)This update processing takes 3 to 4 minutes.  Never turn off the system
      during the update processing. Automatically DC OFF after updating.
    5)Boot the system and Check to make sure the Firmware and SDR version is
      the new version.
      Confirm the update finished successfully or not as follows:
       the messages in boot strapping

        Base Board Management Controller
        Copyright (c) 1999 NEC Corporation, All Rights Reserved
                :                          :
        IPMI Version    :1.0     Firmware version :01.17
        SDR Revison     : SDR Rev.01.00(0252)